Moto-Gauge Installation
Once you have a plan, drain and remove the tank from your bike.
Drill holes and clean out chips Fold string in half and feed into hole...
And out filler neck. Place the nut into the loop.
Pull nut up to back of hole. Hold string and install fitting
Start screw into hole a few turns. Pull out string.
Hold in position and tighten screw. Install remaining fittings.
Three O-rings make a nice clamp. Check tube lengths
Foam can now be installed, but wait until tank is back on bike to install the balance line.
Fill tank a quart at a time (big bikes) or a pint at a time (minis) and position O-rings on the tube at each of the fuel levels.